News

The Real Difference Between Copper and Fiber Patch Panel

Date:07-12-2016

There is no doubt that patch panels are extremely important in cabling systems. You simply cannot have a business or home network (no matter how big or how small) without the use of fiber patch panels. It has been said that patch panels are basically the “nerve center” for a cabling network, and they allow you to fiber cable panel. They also allow the signal to be connected to the final destination.

Patch panels are so critical to a system that if anything goes wrong with them, the entire system may fail. That means that they are very important to your networking system! Patch panels also play a big role in the administration of the telecommunications network. Some believe that they are the absolute only way to successfully transfer lines from one office to the next office.

Since they allow such easy management of cables, it makes sense to choose patch panels carefully. There are copper patch panels and fiber patch panels available. If you use both, it is best to separate the cabling made out of fiber from cabling made from copper. But what if you want to choose between copper and fiber patch panels? Which kind is best?

First, you should know that patch panels are used in fiber cabling networks as well as copper cabling networks. So is there a difference between these two types of cables as far as performance is concerned? Well, most professionals don’t see any differences. But others believe that the fiber patch panels are better, even though they are more expensive than their copper counterpart. In fact, they can be up to 40 percent higher in cost.

When it comes to copper patch panels, each pair of wires has a port. Fiber patch panels require two ports, but no hardwiring is needed. Fiber patch panels are a lot easier to install because of this. The fiber is fed through a coupler.

The real difference between copper and fiber panels

Fiber Adapter Panel can be used for copper and fiber cabling systems. While many people consider that there is very little distinction between fiber and copper systems, it can be common knowledge that fiber panels cost more.

Structurally, copper panels hold the 110-insulation displacement connector style using one side and 8-pin modular ports of the other. Wires getting into the panel are therefore terminated on the insulation displacement connector. In the opposite side, the 8-pin modular connector plugs to the port which matches the terminated wires. With all the copper panel, each couple of wires has an independent port.

Fiber panels require two ports for some wires. One port serves the transmitting end whilst the other handles the receiving end. While fiber panels are generally faster than copper, this may not downplay the role acted as the latter. The fundamental purpose of a patch panel is still in direct signal traffic instead of moving the signal with a precise speed.

In addition, most professionals are in agreement that fiber is a lot faster than copper patch panels. Both types of patch panels must perform according to the same TIA/EIA standards that are needed to produce speed and signal performance for the rest of the cabling network.

Greentelftth are a telecommunication optical distribution network(ODN) manufacturer including Fiber Patch Panel, Fiber Termination Box, Fiber Optic Termination, Fiber Optic Box, Fiber Optical Connector etc.